1. Allows 2 connections at the same time
2. Made from solid brass coated in reinforced polypropylene
3. The polypropylene coating substantially reduces the risk of frost damage and does not tarnish
4. Lever handle for easy on/off operation
5. Complete with 1 sturdy snap on connector
6. Permanently connect one outlet to your water timer / hose pipe / irrigation system / Green house whilst leaving the other outlet free for general use
7. 3/4" BSP male thread plus snap on connector for 1/2" garden hose on the first outlet
8. 3/4" BSP male thread on the second outlet

It can be used with any tank or drum to provide a fully adjustable on/off tap.  With this item you can convert any suitable container into a Water butt or simply add a new or second tap where ever required.

FITTING

Firstly, you will need to drill a hole (25 / 27 mm diameter) where you want to locate the item.  

IMPORTANT.....You must be able to get your hand into the tank or drum somewhere close to enable tightening of the back nut.  You will also need to make sure that the area where the hole is being drilled is reasonably flat.  

You will not get a good watertight seal on a heavily curved surface (a slight contour will be OK).

Once you have drilled the hole, remove the back nut and rubber sealing washer from the adapter and push the threaded section through the hole.  

Then push the rubber sealing washer back over the threaded section and finish by screwing home the back nut as tight as you can by hand.  Do not overtighten.