This is a 3/4" Tank Adapter with a Snap-On garden hose connector at the other end and an Inline Water Filter.

It can be used with any tank or drum to provide a snap-on connection for a standard 1/2" (13 mm) garden hose pipe. It comes complete with a quality snap-on hose connector.

FITTING

Firstly, you will need to drill a hole (25 / 27 mm diameter) where you want to locate the item.

Important.....You must be able to get your hand into the tank or drum somewhere close to enable tightening of the back nut. You will also need to make sure that the area where the hole is being drilled is reasonably flat.

You will not get a good watertight seal on a heavily curved surface (a slight contour will be OK).

Once you have drilled the hole, remove the back nut and rubber sealing washer from the adapter and push the threaded section through the hole.

Then push the rubber sealing washer back over the threaded section and finish by screwing home the back nut as tight as you can by hand. Do not overtight

Water Filter Specification

Suitable for low pressure irrigation systems (up to 3 bar / 45 PSI). The filter can be easily taken apart for cleaning and features an 80 mesh screen filter. Minimal flow loss with maximum efficiency.

Easily taken apart for cleaning. Should be cleaned regularly to achieve the best results.

Effective compact filter with minimal flow loss.