This is a 3/4" Tank Adapter with a TWIN Snap-On garden hose connector at the other end.

It can be used with any tank or drum to provide a TWIN snap-on connection for standard 1/2" (13 mm) garden hose pipe. This version comes complete with 2 quality snap-on hose connectors.

If you already have the hose connectors required to make the connection to the hose, there is also a version available which excludes these.

FITTING

Firstly, you will need to drill a hole (25 / 27 mm diameter) where you want to locate the item.

IMPORTANT.....You must be able to get your hand into the tank or drum somewhere close to enable tightening of the back nut. You will also need to make sure that the area where the hole is being drilled is reasonably flat.

You will not get a good watertight seal on a heavily curved surface (a slight contour will be OK).

Once you have drilled the hole, remove the back nut and rubber sealing washer from the adapter and push the threaded section through the hole.

Then push the rubber sealing washer back over the threaded section and finish by screwing home the back nut as tight as you can by hand. Do not overtighten.